Tuesday, 26 May 2026 | 10:05 | From Gateshead
On Tuesday, 26 May 2026 at 10:05, a Air Ambulance Helicopter departed from Gateshead to Egglescliffe. It was the Air Ambulance Helicopter with registration number G-NHAD. The flight lasted 13 minutes. During that period, the aircraft travelled 32 miles at an average speed of 145 miles per hour at a maximum altitude of 1300 feet.
The helicopter G-NHAD is used as a air ambulance helicopter. The main purpose of this aircraft is to transport a Mobile Medical Team to an incident as quickly as possible, enabling the trauma doctor to provide immediate first aid on site. The aircraft is flying this flight as Air Ambulance Helicopter.
Photo: Samloynes 1
Egglescliffe, Stockton-on-Tees10:19
Egglescliffe, Stockton-on-Tees10:18
Eaglescliffe, Stockton-on-Tees10:17
Preston-on-Tees, Stockton-on-Tees10:17
Elton, Stockton-on-Tees10:16
Stockton-on-Tees, Stockton-on-Tees10:16
Carlton, Stockton-on-Tees10:16
Redmarshall, Stockton-on-Tees10:16
Carlton, Stockton-on-Tees10:16
Stillington, Stockton-on-Tees10:15
Grindon and Thorpe Thewles, Stockton-on-Tees10:15
Sedgefield, County Durham10:14
Fishburn, County Durham10:13
Trimdon Village, County Durham10:13
Trimdon, County Durham10:13
Kelloe, County Durham10:12
Thornley, County Durham10:12
Sherburn Hill, County Durham10:11
Haswell, County Durham10:11
Littletown, County Durham10:11
East Rainton, Sunderland10:10
Hetton-le-Hole, Sunderland10:10
Chilton Moor, Sunderland10:10
Fence Houses, Sunderland10:09
Fence Houses, County Durham10:09
Bournmoor, County Durham10:09
Washington, County Durham10:09
Washington, Sunderland10:08
Washington, Gateshead10:08
Birtley, Gateshead10:07
Chowdene Bank, Tyne and Wear - Gateshead10:07
Gateshead, Gateshead10:06
Gateshead, Tyne and Wear - Gateshead10:05
Air Ambulance Helicopter to Egglescliffe27 Aug 18:26
Air Ambulance Helicopter to Egglescliffe26 Aug 11:36
Air Ambulance Helicopter to Egglescliffe24 Aug 20:24
Air Ambulance Helicopter to Egglescliffe3 Aug 21:11
You can easily display helicopter flights on your own website. Use the embed code.
